Skip to main content
Skip table of contents

IP Address Filter (UE9 Only)

Sets a list of up to five IP addresses that are the only IP addresses that can connect to the UE9. Any unused Addresses can be set to 0xFFFFFFFF (255.255.255.255). If IP #0 is set to 0xFFFFFFFF than the feature is disabled and any IP address can connect.

Command:

 

Byte

 

0

Checksum8

1

0×78

2

0×0B

3

0xAF

4

Checksum16 (LSB)

5

Checksum16 (MSB)

6

Write

7

Reserved

8-11

IP #0

12-15

IP #1

16-19

IP #2

20-23

IP #3

24-27

IP #4

 

 

Response:

 

Byte

 

0

Checksum8

1

0×78

2

0×0B

3

0xAF

4

Checksum16 (LSB)

5

Checksum16 (MSB)

6

Write

7

ErrorCode

8-11

IP #0

12-15

IP #1

16-19

IP #2

20-23

IP #3

24-27

IP #4

  • Write: Set to non-zero if new values should be updated. Pass 0×00 if only reading. A value of non-zero will only work if the command is sent via USB.

  • IP #0: First IP address allowed to connect. A value of 0xFFFFFFFF disables feature.

  • IP #1: Second IP address allowed to connect.

  • IP #2: Third IP address allowed to connect.

  • IP #3: Fourth IP address allowed to connect.

  • IP #4: Fifth IP address allowed to connect.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.