Skip to main content
Skip table of contents

ResetLabJack() [UD Library]

Sends a reset command to the LabJack hardware. Reset causes the device to go to the reset/power-up configuration.

Resetting the LabJack does not invalidate the handle, thus the device does not have to be opened again after a reset, but a Go call is likely to fail for a couple seconds after until the LabJack is ready.

Declaration:

LJ_ERROR _stdcall ResetLabJack ( LJ_HANDLE Handle );

Parameter Description:

Returns: LabJack errorcodes or 0 for no error.
Inputs:

  • Handle – Handle returned by OpenLabJack().

Outputs:

  • None
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.