Skip to main content
Skip table of contents

2.10.1.11 - Period Measurement (16-Bit, Modes 12 & 13) [UE9 Datasheet]

Similar to the 32-bit edge-to-edge timing modes described above (modes 2 & 3), except that hardware capture registers are used to record the edge times. This limits the times to 16-bit values, but is accurate to the resolution of the clock, and not subject to any errors due to firmware processing delays.

Note that the minimum measurable period is limited by the edge rate limit discussed in Section 2.10.2.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.