« Close

Datasheets and User Guides

App Notes

Software & Driver - Input: Driven Signals

The most basic connection to a UE9 digital input is a driven signal, often called push-pull. With a push-pull signal the source is typically providing a high voltage for logic high and zero volts for logic low. This signal is generally connected directly to the UE9 digital input, considering the voltage specifications in Appendix A. If the signal is over 5 volts, it can still be connected with a series resistor. The digital inputs have protective devices that clamp the voltage at GND and VS, so the series resistor is used to limit the current through these protective devices. For instance, if a 24 volt signal is connected through a 22 kΩ series resistor, about 19 volts will be dropped across the resistor, resulting in a current of about 0.9 mA, which is no problem for the UE9. The series resistor should be 22 kΩ or less, to make sure the voltage on the I/O line when low is pulled below 1.0 volts.

The other possible consideration with the basic push-pull signal is the ground connection. If the signal is known to already have a common ground with the UE9, then no additional ground connection is used. If the signal is known to not have a common ground with the UE9, then the signal ground can simply be connected to UE9 GND. If there is uncertainty about the relationship between signal ground and UE9 ground (e.g. possible common ground through AC mains), then a ground connection with a 100 Ω series resistor is generally recommended (see Section

Figure Driven Signal Connection To Digital Input

Figure shows typical connections. Rground is typically 0-100 Ω. Rseries is typically 0 Ω (short-circuit) for 3.3/5 volt logic, or 22 kΩ (max) for high-voltage logic. Note that an individual ground connection is often not needed for every signal. Any signals powered by the same external supply, or otherwise referred to the same external ground, should share a single ground connection to the UE9 if possible.

When dealing with a new sensor, a push-pull signal is often incorrectly assumed when in fact the sensor provides an open-collector signal as described next.