2.8.1 - Typical Analog Output Connections [UE9 Datasheet] | LabJack
 
« Close

Datasheets and User Guides

App Notes

Software & Driver

 
Wednesday April 1st, 2020
Support: LabJack engineers available through email and chat.
Shipping: We are processing and shipping all orders.
Stock: 55/56 products in stock. More details.
Supply Chain: Some disruptions. More details.

2.8.1 - Typical Analog Output Connections [UE9 Datasheet]

The DACs on the UE9 can output quite a bit of current, but have 50 Ω of source impedance that will cause voltage drop. To avoid this voltage drop, an op-amp can be used to buffer the output, such as the non-inverting configuration shown in Figure 2-3. A simple RC filter can be added between the DAC output and the amp input for further noise reduction. Note that the ability of the amp to source/sink current near the power rails must still be considered. A possible op-amp choice would be the TLV246x family (ti.com).