Skip to main content
Skip table of contents

2.9.1.5 - Firmware Counter Input (Mode 5) [U6 Datasheet]

On every rising edge seen by the external pin, this mode increments a 32-bit register. Unlike the pure hardware counters, these timer counters require that the firmware jump to an interrupt service routine on each edge.

Writing a value of zero to the timer performs a reset. After reset, a read of the timer value will return zero until a new edge is detected. If a timer is reset and read in the same function call, the read returns the value just before the reset.

Edge Rate Limits

This edge-detecting timer mode requires processing resources as an interrupt is required to handle each edge.  See more about edge rate limits in Section 2.9.2.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.