2.2 - Power and Status LED [U6 Datasheet] | LabJack
« Close

Datasheets and User Guides

App Notes

Software & Driver

Wednesday April 8th, 2020
Support: LabJack engineers available through email and chat.
Shipping: We are processing and shipping all orders.
Stock: 55/56 products in stock. More details.
Supply Chain: Some disruptions. More details.

2.2 - Power and Status LED [U6 Datasheet]

There is a yellow “Power” LED to indicate power, and a green “Status” LED controlled by the main processor.

The Power LED is connected to VS (with a series resistor). It indicates that some voltage is present on VS, but does not indicate whether the voltage is valid or not.

The Status LED flashes on reset and USB enumeration, then remains solid on with flashes to indicate communication (USB) traffic.

Normal Power-Up Status LED Behavior: When the USB cable is connected to the U6, the Status LED should blink a few times and then remain solid on.

LED blinking continuously at about 4 Hz, even with no software running: This indicates that the U6 is in flash mode. See Section 1.2 and reprogram the device.


Is there a way to check the status of the LabJack remotely?

You mean via Internet?  What are you using for software?