Skip to main content
Skip table of contents

4.37 - WriteMem [U12 Datasheet]

Writes 4 bytes to the LabJack’s 8,192 byte nonvolatile memory at a specified address. The data is read back and verified after the write. Memory 0-511 is reserved for configuration and calibration data. Memory from 512-1023 is unused by the LabJack and available for the user (this corresponds to starting addresses from 512-1020). Memory 1024-8191 is used as a data buffer in hardware timed AI modes (burst and stream).

Execution time for this function is 20 milliseconds or less (typically 16 milliseconds in Windows).

Declaration:

long WriteMem ( long *idnum,
long unlocked,
long address,
long data3,
long data2,
long data1,
long data0 )

Parameter Description:
Returns: LabJack errorcodes or 0 for no error.
Inputs:

  • *idnum – Local ID, serial number, or -1 for first found.
  • unlocked – If >0, addresses 0-511 are unlocked for writing.
  • address – Starting address for writing (0-8188).
  • data3 – Byte for address.
  • data2 – Byte for address+1.
  • data1 – Byte for address+2.
  • data0 – Byte for address+3.

Outputs:

  • *idnum – Returns the local ID or –1 if no LabJack is found.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.